View Single Post
Old 07-26-2014, 02:21 PM   #1980
02 RS
Scooby Newbie
 
Member#: 120233
Join Date: Jul 2006
Chapter/Region: SWIC
Location: Black hole P-town, AZ
Vehicle:
2003 WRX
Silver RWD Bastard Child

Default

Quote:
Originally Posted by mj213 View Post
You mean the one that threads through the hub perpendicular to the axle? I was going to remove the axle and reseat it. That would give me the chance to check to make sure the clip is still intact.
That's the one. U have to undo that anyway if your going to re seat the axle. That think can be a PITA to get out sometimes. When removing it, put a jack under the rear hub where the trailing arm bolts up to the hub and jack it up to take some of the pressure off of it. Makes it easier. Then, after you inspect the clip put the outer axle back in the hub and use the hub to seat it in the diff by pushing inwards.
* Registered users of the site do not see these ads.
02 RS is offline   Reply With Quote