Thread: Tapping for oil
View Single Post
Old 07-28-2003, 02:47 PM   #2
PHATsuby
Scooby Guru
 
Member#: 13617
Join Date: Dec 2001
Chapter/Region: MWSOC
Location: MN
Vehicle:
2001 Legacy GT back
to stock is a project too

Default

are you doing this for an oil gauge or for a turbo feed line? if you have a kit(i have a ludespeed) it comes with a bolt than goes into that hole and then you just screw another adapter in then the feed line, but the threads into the block seemed a little iffy, luckily i had an extra subaru galley plug that i didnt use for my oil guage and also a 1/8 BSPT to 1/8 NPT adapter that was not being used so i just used those and it screwed together no problems i have to yet to see if it leaks but it shouldnt.

hope that helps

Ben
* Registered users of the site do not see these ads.
PHATsuby is offline   Reply With Quote