View Single Post
Old 08-30-2003, 08:48 PM   #1
MyRuRex
Scooby Specialist
 
Member#: 21349
Join Date: Jul 2002
Chapter/Region: Tri-State
Location: New York
Vehicle:
02 WRX Wagon
PSM

Default Greddy Profec-B Spec II Help

Just installed this baby. Looks awesome....mounted right above the steering wheel column. I took out the "P" switch.
BUT...how the heck do you set up this thing???

Lo/Hi boost is not working right....I'm getting higher boost in the Lo setting eventhough the Hi setting is set higher. The directions that came w/this are worth ****ake

I have a Unichip Stg 1......was set at 1.1 bar (~16psi) w/the MBC
The problem w/this is that the settings is based on percentage....it's not making sense. I set it @ 100% and that goes way up to about 1.5 bar at part throttle in 1st gear!!! When I turn it down......I can't even get up to stock boost (~14.5psi)!!

What's up

Another problem is.....My BOV isn't blowin off!! My guess is I have to many T's in that area.....It's like a LA freeway in the BOV area. I also have a mechanical boost gauge in that area.....

I know I'm just yappin away but HELP !!!!!!
* Registered users of the site do not see these ads.
MyRuRex is offline   Reply With Quote