View Single Post
Old 11-14-2003, 07:45 AM   #6
RidinLow
Scooby Guru
 
Member#: 329
Join Date: Sep 1999
Chapter/Region: Tri-State
Location: NJ
Vehicle:
1995 325i
Arctic Gray

Default

I installed mine a bit differently. I took a small plate of aluminum, cut it to roughly fit the very bottom of each housing, and drilled 3 holes in it. 1 hole was for the 500 mounting bolt and the other two holes were to fasten the plate to the bumper cover (there are already 2 conveniently placed, unused holes for this purpose).

* Registered users of the site do not see these ads.
RidinLow is offline   Reply With Quote