Basically, almost finished with my remote start setup (04 STi - Omega Rallystarter), however I'm having issues getting a bypass relay to work right.
So I have setup a relay as described in the "Ultimate Alarm Thread".
85 - Trigger for starter wire coming from remote start
86 - Constant 12v
30 - Clutch wire (highest switch)
87 - Clutch wire (highest switch)
Now, problem is when I depress the clutch, I get this awful buzzing sound from what looks like the clutch switch itself, can't be good.
If I disconnect the 12v constant it goes away. I have verified the clutch wires are tapped correctly, if I loop them together I have a constant bypass.
My 12v tap shows 12v and my starter wire shows 4+v. I am thinking the starter wire (fairly large guage which goes from the remote starter to my oem security starter interrupt) may not be correct.
Now looking at NetZ's specs on
Dreamspeed I see the following recommendation :
1) Pin 86 to 2nd Ignition Output off Remote Start relay pack
2) Pin 85 to Blue Status Output off Alarm/Remote Start unit
3) Pin 87 to Ground or Ground side of Clutch Switch
4) Pin 30 to Non-Ground side of Clutch Switch
Now I have a 2nd ignition output which is used, no voltage showing. However, I do not appear to have an equivalent blue status output.
Any suggestions here would be great. Thanks again.
