View Single Post
Old 02-08-2004, 10:17 PM   #3
BritSti
Scooby Newbie
 
Member#: 38057
Join Date: Jun 2003
Location: Hingham, MA
Vehicle:
2010 IS-F
USB

Default

Thanks for the help once again Netz. This has been a little harder than I though for a fairly plug and play kit.

My activation input is looking for the locking system lock wire, which could be on the keyless entry module or the integrated module.

The manual specifies yellow/red at pin 11 on the integtrated module blue connector... its not there, there is a yellow/red at pin 11 on the grey connector, does not work.

The orange white wire on the keyless module starts out at 11+v and does almost dip to 0v when the lock is acutated, so this may work.

I have checked virtually every wire on the keyless and integrated modules and none show negative when "lock" is activated...

My activation wire (looking for a double ground pulse) works fine to initiate the remote starter if I physically ground it out twice.

Would the blue wire on the integrated module send ground twice if the lock button is hit twice...?

Thanks for any advice on this.

S
* Registered users of the site do not see these ads.
BritSti is offline   Reply With Quote