View Single Post
Old 02-08-2004, 10:30 PM   #4
netZ
Scooby Specialist
 
Member#: 5743
Join Date: Apr 2001
Chapter/Region: Tri-State
Location: nj/nyc
Vehicle:
2007 Kia Optima
gold brick

Default

the yellow/red a11 is found on the 02/03 wrx. it's the actual door lock switch output. for the 04 the yellow/red b11 is found at b281 gray. this is the door lock switch output which is tied to the integrated module and the keyless entry module.

if you were to tap this wire to your trigger input, pressing the door lock twice should activate it as well.

netZ

Quote:
Originally posted by BritSti
Thanks for the help once again Netz. This has been a little harder than I though for a fairly plug and play kit.

My activation input is looking for the locking system lock wire, which could be on the keyless entry module or the integrated module.

The manual specifies yellow/red at pin 11 on the integtrated module blue connector... its not there, there is a yellow/red at pin 11 on the grey connector, does not work.

The orange white wire on the keyless module starts out at 11+v and does almost dip to 0v when the lock is acutated, so this may work.

I have checked virtually every wire on the keyless and integrated modules and none show negative when "lock" is activated...

My activation wire (looking for a double ground pulse) works fine to initiate the remote starter if I physically ground it out twice.

Would the blue wire on the integrated module send ground twice if the lock button is hit twice...?

Thanks for any advice on this.

S
* Registered users of the site do not see these ads.
netZ is offline   Reply With Quote