View Single Post
Old 02-09-2004, 01:49 PM   #8
netZ
Scooby Specialist
 
Member#: 5743
Join Date: Apr 2001
Chapter/Region: Tri-State
Location: nj/nyc
Vehicle:
2007 Kia Optima
gold brick

Default Re: Complete Omega Rallystarter Instructions

no, you don't want to send 12 volts to the clutch switch wire. it needs to see ground. that's why i suggested using the IGN2 12 volt output to a 12 volt relay to either connect the 2 clutch switch wires or just send Ground to the non-ground side of the switch.

Not sure about the Omega unit but typically the ACC outputs of a remote start system come on after the Starter receives 12 volts. This delay may prevent the clutch bypass from working properly.

Please test the ACC output to see it's behavior to see if it comes on during the Starter crank.

netZ

Quote:
Originally posted by BritSti
OK, Here is the rest of the manual .

Now for shouldn't the white dedicated parking light wire off the remote starter pack work for me to activated the clutch bypass, as this should only receive 12 volts when remote starting correct??

Pg1
Page 2-3
Page 4-5
Page 6-7
Page 8-9
Page 10-11
* Registered users of the site do not see these ads.
netZ is offline   Reply With Quote