Thread: 04 tailights
View Single Post
Old 02-12-2004, 07:45 PM   #10
ljaviation
Scooby Specialist
 
Member#: 42270
Join Date: Aug 2003
Chapter/Region: South East
Location: Asheboro, NC
Vehicle:
2003 A&P IA
ww.flyingleafaviation.com

Default

I used a small round carbide bit with a med cut. I put masking tape on the bumper cover.. put the new tail light up to
where it bolts in, and traced the two areas where I needed to trim. One area is the one under the round portion of the light and the other is on the lower outside corner. You can't miss it. Take a little off at a time and keep checking your work.
* Registered users of the site do not see these ads.
ljaviation is offline