View Single Post
Old 06-28-2001, 02:26 PM   #9
dvancleve
Scooby Specialist
 
Member#: 5211
Join Date: Mar 2001
Chapter/Region: SWIC
Location: Chandler, AZ
Vehicle:
2007 Outback XT Ltd.
Diamond Gray Metallic

Default I think Kartboy bushings are harder...

Quote:
Originally posted by Scoob_13
I recently installed the Syms kit + cusco bushings on my car..

I would highly, highly suggest the cusco bushings, they seem to be the hardest ones out there, and offer the greatest advantages. Also, I would not suggest installing a $300 shift kit when its only the lever and the bushings that are different (didn't notice any difference between the bushings where they meet to the back of the tranny tunnel). But thats for you to decide =)
I think Kartboy bushings are probably harder (I have Cusco). Doesn't N1 or somebody make a bushing set that is Delrin? This is a hard white nylon and would be harder than either Cusco or Kartboy...

Doug

Edit: I just pulled out my RS shifter and replaced it with a Graham Goode. I have the Cusco bushings. I have noticed a buzzing/humming noise that seems to be coming through the shifter since I changed it. It isn't bad, and there isn't any visible vibration, but I didn't notice it before with the RS shifter. I wonder if the rubber in the middle dampens the vibration on the RS shifter?
* Registered users of the site do not see these ads.

Last edited by dvancleve; 06-28-2001 at 02:52 PM.
dvancleve is offline   Reply With Quote