View Single Post
Old 04-26-2004, 01:22 PM   #13
jmott
Scooby Guru
 
Member#: 6713
Join Date: May 2001
Chapter/Region: TXIC
Location: Houston TX USA
Vehicle:
2007 Prius
brown

Default

gotcha

would be interesting to do some testing to see at what point more front roll stiffness starts to hurt grip more than help.

Im planning on getting that "geez" device so I can do stuff like that with my new toy.


Quote:
Originally posted by Watkinsm3
with the strut style suspension the amount of camber gain through compression is so small compared to roll over due to body motion. This is obvious from tire wear (i just corded two victoracers up front this weekend)... why? they corded on the front and the VERY outside edge was what went (about a half inch from the line that sperates the sidewall from the tread. The insides are near full tread. So the concept behind it is to help keep the tire flat in the corners with the limited negative camber gain (this ain't no double wish bone!!!). How do you do that? reduce body roll. How do you reduce body roll up front in stock? Massive stiffening of the front rollbar. Test different settings till you find the optimal balance between stiffness and contact patch.

If you get it right... the car should loosen up on turn in... exactly where it needs it. I'm still testing these things but I believe the theory sound. I believe that some of the FWD stock tuning techniques (such as a smaller front bar) should NOT be used with the STi. The vehicle should be treated as a strut equiped RWD car for setup purposes.

Adjustable front bar should be on the car next week... combined with an alignment this week (with weekend testing in between). We shall see... I'll have good benchmark drivers both weekends to help figure if an advantage was achieved. Then, of course, DC at the end of may.

-Matt
* Registered users of the site do not see these ads.
jmott is offline   Reply With Quote