Thread: Engine Studs
View Single Post
Old 05-02-2004, 07:20 PM   #8
Brindor2.5
Scooby Newbie
 
Member#: 40657
Join Date: Jul 2003
Chapter/Region: NESIC
Location: Maine
Vehicle:
2008 Impreza WRX
Spark Silver

Default

Got the old studs out and put the new ones in. Used the two nut trick, worked good. So i've got the new headers on (wicked awesome) but i've got another question. When i installed i tightened the nuts on the studs, then just cus its the way that i am, after driving around for a while and letting the car cool down i checked them. They we not real loose but i could tighten them, is this normal?
I thighted then and will check them again tomorrow.
* Registered users of the site do not see these ads.
Brindor2.5 is offline   Reply With Quote