View Single Post
Old 08-20-2004, 05:33 PM   #2
ajabobrut
Scooby Specialist
 
Member#: 56726
Join Date: Mar 2004
Location: Cantonment,FL
Vehicle:
2004 Baja Turbo
Regatta Red Pearl

Default

Quote:
Originally Posted by Texas S
Has anyone tried removing the trim in the bed?

I'm wanting to get the rollbars off but don't want to trash the plastic clips and plugs while I'm at it... found instructions for installing sports lights that shows the inside trim walls coming off but can't tell much from the pics (https://www.1stsubaruparts.com/libra...ivity_Lamp.pdf) and they mention needing replacement plastic clips?


Man what a job,they have you stripping all the plastic off cause everything over laps.I did mine different,and it was still a bitch to do.Pull the 3rd brake light and to the right is the plug you connect to.Pop out the square plugs on the roof plastic that holds the light assy and take out the screws.I can't remember if the plastic upper ring around the bar will slide down out of the way.There's a plastic plug on the bottom.


I had pryed up on the plastic panel(be careful not to break it) and slid the small connector through the hole where the brake light goes and out the other side,then slide the harness down to the corner its a little tight,trim the rubber strip first.Once you get past this part,its down hill from there.I forgot the other hard part,plugging up the switch.Get ready to pull the radio,i had a hard time finding the harness for the switch even with the radio out.Pull the roof bar off and mount the lights and strap down the harnesses then reinstall the light bar get the lights set and tighten them down,hpoe this helps.Good luck.
* Registered users of the site do not see these ads.
ajabobrut is offline   Reply With Quote