View Single Post
Old 09-04-2004, 07:18 PM   #2
squeech
Scooby Specialist
 
Member#: 38280
Join Date: Jun 2003
Chapter/Region: RMIC
Location: Lakewood, Colorado
Vehicle:
2000 2.5RS w/ EJ205
tuned @ teh Ghetto Garage

Default

From the engine manifold or the cat?

I had more trouble removing the bolts at the cat flange than from the engine. The manifold nuts were quite tight from the factory, but I was able to pull them off with a simple 14mm socket and a 6 inch extension, and then by hand after a few turns. The bolts themselves are studs in the engine, and don't come off (but I'm sure you knew that )

If anything, you should really only need some WD-40 if they are rusted on or something.
* Registered users of the site do not see these ads.
squeech is offline   Reply With Quote