View Single Post
Old 10-17-2004, 05:48 PM   #1
ilmaestro
Scooby Specialist
 
Member#: 16004
Join Date: Mar 2002
Location: Folsom, CA
Vehicle:
1998 2.5 RS - Blue
Dreaming of Boost

Default Brullen header/cat install question

Edit: The parts are installed My review:

http://forums.nasioc.com/forums/show....php?p=7904114

(original message)

Hey all,

I just got a nice used brullen header and NEW brullen cat Yay! Currently I have a stromung muffler and stock midpipe so I need to figure out the best way to add on the header/cat, and decide what to do about the midpipe. I 'think' the stromung muffler piping is 2.25" and the brullen piping is 2.5"... so going with a 2.25" or 2.5" midpipe would be fine...? Anyone know about this?

My other questions would be, how do the cat and the midpipe bolt up to each other? The cat has a flange on it of course, but there's also a donut thing that I got with the cat that is suppose to weld to the midpipe or something? I was thinking of going to my local exhaust shop to have a new midpipe made since my stock one will suck with the new setup... but will I even be able to install the header/cat right now, to the stock midpipe?

Lots of questions. If anyone can give me some general insight, it would be much appreciated.

jonathan
* Registered users of the site do not see these ads.

Last edited by ilmaestro; 10-24-2004 at 05:05 PM.
ilmaestro is offline   Reply With Quote