View Single Post
Old 11-15-2004, 10:32 PM   #1
NMLegacy
Scooby Newbie
 
Member#: 40866
Join Date: Jul 2003
Location: New Mexico
Vehicle:
2005 LGT 5MT wagon
2006 FXT Ltd

Default Question for USDM STI ECM experts

I searched the forums for an answer to my question and found nothing, if I missed it I apologize in advance. Anyway, I am in the process of installing an '04 USDM STI engine w/ECM and wiring in my '00 Legacy. I am not using the transmission, thus no DCCD. My goal is to be able to use the on board diagnostics so I want no trouble codes. I believe I have got the wiring worked out with the exception of what do I have to do with the three circuits interconnected with the DCCD Control Unit.

Specifically:
B134, 23 (connector, circuit); connected to instrument cluster interface and DCCDCU in the STI
B136,28; connected to Accl Position Sensor and DCCDCU in the STI
B137,20; connected to Datalink Connector and DCCDCU in the STI

Do I just hook up to the appropriate items in the Legacy and forget about anything regarding DCCD, add a resistor load in parallel, or what? Any advice would be greatly appreciated.

Cheers!
* Registered users of the site do not see these ads.
NMLegacy is offline   Reply With Quote