View Single Post
Old 11-22-2004, 09:47 AM   #1
zombiedog
Scooby Specialist
 
Member#: 25138
Join Date: Sep 2002
Chapter/Region: MAIC
Location: DC - MD
Vehicle:
85 e30
PRIMERZ!

Default Info for when you tear up your injector o-rings

The dealership tried to charge me 36$ and some change for 4 tiny o-rings that go onto the injector tops. These are commonly torn when people change their injectors.

After some research and looking around at my favorite site mcmaster.com I found that the 8mm ID by 2mm thick o-rings are an exact match. Part #9263K169. These are the ones made out of Viton which are the oil/gas resistant kind.

I also tested out and found that the 7mmx2mm are better because they fit more snugly and have less of a tendency to tear during installation. I did test this and I'm currenly running it on my car.

A pack of 25 is 9$ which is what they were going to charge me for one!!!

Edit: Also you usually get them overnight through their regular shipping.
* Registered users of the site do not see these ads.

Last edited by zombiedog; 11-22-2004 at 09:54 AM.
zombiedog is offline   Reply With Quote