View Single Post
Old 12-03-2004, 03:11 PM   #4
kwh29
Scooby Specialist
 
Member#: 22100
Join Date: Jul 2002
Chapter/Region: South East
Location: Durham, NC
Default

I had the shop do the mods -- the front and middle section fit perfectly. The brackets on the tranny even match!

The shop moved the first hanger (on the midpipe) back about 2" and down about 1/2"

They added about 4-1/2" to the straight part of the rear section directly under the axle.

They cut off the hanger directly behind the axle then welded the cut part back on in a way that works.

They cut off the drivers side rear hanger and rotated it around then welded it back on. The pass. side rear hanger fits perfectly without modification.

I'm using the O2 bung that's on the rear cat. This is probably not ideal but the car works and there's no black clouds so I'm not too worried.

It was sort of expensive -- $55 after the club discount.

--Kevin H.
* Registered users of the site do not see these ads.
kwh29 is offline   Reply With Quote