View Single Post
Old 12-29-2004, 11:53 PM   #1
Sean
Scooby Guru
 
Member#: 518
Join Date: Nov 1999
Chapter/Region: NESIC
Location: Trunkmonkey Racing
Vehicle:
762 PGT Impreza L,
Silverado EXT, Yaris

Rally Stuff Tie rod boot/steering rack grease? Replacing torn boot.

OK, I'm replacing a torn tie rod boot on the rally car (steering rack end, not the knuckle end) and I'm trying to figure out what grease to use once I clean out all the grit and nasties (D3 below). The only reference I've been able to find on the board is this vague reference to not add more grease:

Quote:
Originally Posted by vvk
http://forums.nasioc.com/forums/show...64&postcount=6
You do not need any grease. Just leave whatever grease exists on the rack well alone.
The boot in question is the one pictured in the bottom-left hand corner that covers D3. The factory service manual says to use "genuine grease", but I'd rather just go to Advance Auto Parts or Auto Zone instead of spending some exuberant amount at my local dealer. Any suggestions?



NESIC Web Site | Trunkmonkey FAQ | Trunkmonkey Racing | Trunkmonkeys in Action
* Registered users of the site do not see these ads.

Last edited by Sean; 12-30-2004 at 03:36 PM.
Sean is offline   Reply With Quote