View Single Post
Old 01-08-2005, 02:59 PM   #1
santofontana
Scooby Specialist
 
Member#: 26876
Join Date: Oct 2002
Chapter/Region: NESIC
Location: 1990 GMC Sierra 4x4 350ci
Vehicle:
1994 Camaro Z28 383
Black M6

Default wandering idle with valet mode [utec]

I had to valet my car a few times last week so I had the utec on valet mode, which seemed to work, except for the idle was wandering, and I could see my vaccuum fluctuating and the AFRs going way more rich and then lean than it normally does.

When I got in my car to go home, the guy had turned it off, so I switched the remote switch to one of my maps and tried to start the car, but it wouldnt start, it only cranked. Cycling the key didnt help,and the check engine light wasnt flashing when I turned the key on, I had to disconnect the battery and reconnect it to get the car started again.

Anybody had this problem before?
* Registered users of the site do not see these ads.
santofontana is offline   Reply With Quote