View Single Post
Old 01-10-2005, 12:17 AM   #2
Focus4
Scooby Specialist
 
Member#: 20107
Join Date: Jun 2002
Chapter/Region: Tri-State
Location: Northern NJ
Vehicle:
2004 STi
WRB

Default

If you run the AP maps as a base map then yes they will remove the EGT cel. You can check on the cobb site, but stage 2 removes these cels:

CEL Codes Defeated [WHEN USING AS BASE MAP]
(** means new to latest revision):
P0037 - Rear O2 Sensor Heater Control Circuit Low **
P0038 - Rear 02 Sensor Heater Control Circuit High **
P0137 - Rear O2 Sensor Low Voltage **
P0138 - Rear O2 Sensor High Voltage **
P0139 - Rear O2 Sensor Circuit Slow Response **
P0420 - Catalyst System Efficiency Below Threshold
P0545 - Exhaust Gas Temperature Sensor Circuit Low
P0546 - Exhaust Gas Temperature Sensor Circuit High
P1301 - Misfire Detected (High Temperature Exhaust Gas) **
P1312 - Exhaust Gas Temperature Sensor Malfunction **
P1544 - Exhaust Gas Temperature Too High **


stage 1 removes most of them too..
* Registered users of the site do not see these ads.
Focus4 is offline   Reply With Quote