View Single Post
Old 01-23-2005, 06:56 PM   #2
finnRex
RIP Donny
Moderator
 
Member#: 21095
Join Date: Jul 2002
Chapter/Region: TXIC
Location: Miss you, Charlie Murphy.
Vehicle:
RIP KTH & LMFH
'09 Crystal red Tintcoat

Default

If you change the base map, you gotta connect the green connectors under the steering wheel. Once you connect those greens, turn the key on. Connect the AP with the OBD II port, and select base map. Turn all accessories off(interior/exterior light, radio), and select change base map. Once your base map has been flashed, take the AP out of the port and disconnect the green connectors. After that, change your realtime map to stage 2. That should be it.



Mika
* Registered users of the site do not see these ads.
finnRex is offline   Reply With Quote