View Single Post
Old 10-29-2000, 08:24 AM   #8
Shik
NASIOC Supporter
 
Member#: 132
Join Date: Jul 1999
Chapter/Region: Tri-State
Location: Central PA
Vehicle:
2006 GT Ltd 5spd sdn
2015 WRX 6spd CWP

Post

Ben, did you try a few washers under the strut tower bar mounting bolts( on the underside of the bar). It may be enough to raise the bar over the intercooler, but not too much so the bar hits the hood. May be worth a try. STi's non-carbon fibre strut tower brace worked with the WRX intercoolers by just going over the top of the back of the intercooler, not around it like most so it may work.
* Registered users of the site do not see these ads.
Shik is offline   Reply With Quote