View Single Post
Old 03-24-2005, 07:40 PM   #29
raamaudio
Scooby Specialist
 
Member#: 50340
Join Date: Dec 2003
Location: Morgan Utah
Vehicle:
05 FXT
Crystal Grey Metalic

Default

This issue seldom happens but there are ways to make sure it does not, the rear foam cover things are ok but you must have as much cut out as possible so the rear of the speaker cone can move freely in the air around it, if not you will cause distortion in the output due to uneven resistance on the cone.

I have made a lip over the top of the speaker out of mat and others out of flexible plastic glued on, etc.

Rick
* Registered users of the site do not see these ads.
raamaudio is offline   Reply With Quote