View Single Post
Old 03-24-2005, 10:02 PM   #31
RodimusPrime
Scooby Newbie
 
Member#: 82118
Join Date: Feb 2005
Chapter/Region: MAIC
Vehicle:
2005 GD6 2.5RS
Crystal Gray Metallic

Default

Quote:
Originally Posted by raamaudio
This issue seldom happens but there are ways to make sure it does not, the rear foam cover things are ok but you must have as much cut out as possible so the rear of the speaker cone can move freely in the air around it, if not you will cause distortion in the output due to uneven resistance on the cone.

I have made a lip over the top of the speaker out of mat and others out of flexible plastic glued on, etc.

Rick

Ok well I intend to take a lot of pictures of this install once I start so hopefully we can get some guide up here for everyone's benefit. I really don't want my new speakers to get all rusty!!
* Registered users of the site do not see these ads.
RodimusPrime is offline   Reply With Quote