View Single Post
Old 03-26-2005, 01:27 AM   #35
jonney_boy
Scooby Specialist
 
Member#: 28747
Join Date: Nov 2002
Chapter/Region: VIC
Vehicle:
06 WRX

Default

How would you go about matting the outer door skin? (i've only taken an Acura CL door appart, but I assume other cars should be similar).

When you take the door panel off (the interior trim piece) you basically expose 3 surfaces in the following order. A "inner" door skin/frame. Then you have the glass, and then you have the outer door skin.

The inner door skin only has a few big holes cut in it, do you roll the window up (to get it out of the door) then apply the mat to the outer door skin? do you have to worry about denting the outer door skin when you roll the mat on (I would hate to finish installing my audio system only to walk outside and realized I just screwed up all my doors!)? Also, would it not be VERY difficult to get large sheets of mat (and try and work it onto the outer door skin) using only the small access holes?
* Registered users of the site do not see these ads.
jonney_boy is offline   Reply With Quote