View Single Post
Old 04-14-2005, 09:24 PM   #16
antimullet
Scooby Specialist
 
Member#: 44193
Join Date: Sep 2003
Chapter/Region: South East
Location: Relocated to Raleigh, NC
Vehicle:
2008 WRX STi
Silver

Default

Hey Offset,

How was the drive home tonight? Hopefully the adjustments to the PWM2 map were good.

BTW, I checked my pwm2 and it was the same exact setting that Andrew recommended to you and fixed your high idle.

Phil, we had a high idle to 2000rpm tonight on Offset's car. Couldn't get it to settle and it wasnt DBW safe mode cause the TPS CAL and the throttle still worked.
It was acting just like a stuck butterfly, and playing wuth the throttle wiould get it to settle back down.

I set his boost down to 14.9 psi max with no overshoots say +2psi since his WBO2 needs fixed.

Anyhow, we needed (After about a half hour with Andrew on the line from Hydra) to adjust the PWM2 basically so the upper limits were around 74.8 and the 0 column startup was around 22.8 if memory serves. Anyhow same as I have setup now.

Once I get the boost and fuel/timing tweaked a little more I'll send you the map/logs for some expert insight on both mine and Offsets.

Thanks Andrew and Phil!
Aaron
"Antimullet"
* Registered users of the site do not see these ads.
antimullet is offline   Reply With Quote