View Single Post
Old 10-10-2001, 12:26 PM   #2
Bob O
Scooby Specialist
 
Member#: 1502
Join Date: May 2000
Chapter/Region: MAIC
Location: Felton, PA, USA
Vehicle:
2000 2.5RS & SV1kS
BRP

Default

IIRC, it's not a simple task, not like repacking rear wheel bearings on a FWD car. You need some larger tools (arbor press) and stuff. I don't know for sure though, as I've never done it, but I'll try to check my shop manuals (the manuals are for a 00, but it should be the same or close). Which side wheel was it in the rear?

You might not want to wait too long if it is indeed the bearing as it can seize completely and then ruin the hub as the outer race will spin with the shaft inside the hub (it's what's refered to as a "spun" bearing).

There are a number of posts about this, and they may have more info on what's required.

Bob
* Registered users of the site do not see these ads.
Bob O is offline   Reply With Quote