View Single Post
Old 04-06-2005, 06:44 AM   #20
ToddStratton
Scooby Specialist
 
Member#: 8351
Join Date: Jul 2001
Location: Alabama
Vehicle:
2002 WRX Wagon

Default

The diagram on their site (link above) matches exactly to what I have in front of me (the flat base). I have not put the base into the car yet, but it appears to have correct bolt locations and design. The instructions specifically say to use the "inner holes" which are the only ones that work with the sliders anyway.

The Evo2 may be too wide, but based on the specification sheet (and the difference between the two), so would the Evo.

Does anyone have an Evo2 mounted in an Impreza and has a picture of their setup they can share?

Strangely enough, the local shop I got the seat from (they are much cheaper in Europe) couldn't get the "new" flat mounting brackets, so I ordered those from the U.S. I'll take a picture of what I have put together and post it.

Edit: I measured a few things:

Width of Evo2 seat at mounting point (17")
Width of flat seat base "inner" holes - 14.5 inches
Width of outer holes - 16.5 Inches
Span of slider handle - 11 inches

Drilling new holes (one on each side) in the sliders will make this work when attached to the outer holes, except the slider handle will have to be cut or ditched in favor of two levers.


Thanks,
Todd
* Registered users of the site do not see these ads.

Last edited by ToddStratton; 04-06-2005 at 06:57 AM.
ToddStratton is offline   Reply With Quote