View Single Post
Old 09-13-2012, 08:30 PM   #105
Overland04
Scooby Specialist
 
Member#: 293311
Join Date: Sep 2011
Chapter/Region: NESIC
Location: Coast of Maine
Vehicle:
2013 FXT 6-Speed
Obsidian Black Pearl

Default

Quote:
Originally Posted by garudatwo
Hey boss, can you take a pic of the ATI gauge pod from the back? Does it insert into the clock pod's gap? Also, when you relocated the clock to the cubby, did you have to do any additional wiring? Going to get my boost/oil pressure/wideband next week.
Hey man,
The pod sits on the dash and only uses the lip to hold the back of the pod in. My Camera is at work so I can maybe snap a shot tomorrow evening. The clock relocation will require you to extend the 7 pin harness about 18". I used a leftover radio harness but a normal cat5 cable will work too.

Cheers mate!
* Registered users of the site do not see these ads.
Overland04 is offline   Reply With Quote