View Single Post
Old 05-11-2012, 08:26 AM   #420
Gfunk720
Scooby Guru
 
Member#: 42549
Join Date: Aug 2003
Chapter/Region: Tri-State
Location: You can find me in the 203
Vehicle:
E92 M3
B9 Audi SQ5

Default

Quote:
Originally Posted by SWP n Gold View Post
Alright, so after my lowering springs were re-installed by a shop, I noticed the wheel gap on the front/passenger side was .5" larger than the other 3 wheelwells. When I look under the hood at the strut mounts, the 3 bolts holding down the passenger side strut mount are taller than the bolts holding down the driver's side strut mount; they should be the same on both sides. Is this installation error and would I have to get the entire spring/strut assembly uninstalled/re-installed to fix the situation?
Definitely take some pics. Unless they put the wrong strut in there though, the studs should be the same height. You likely have something else going on though that is causing the issue. The spring may not be seated properly.


I used to go to On Track up in Wallingford. Definitely some more technical racing and a good track layout. Is it a flat track, or does it have inclines? The Wallingford one was perfectly flat, which is a little less exciting.
* Registered users of the site do not see these ads.
Gfunk720 is offline   Reply With Quote