View Single Post
Old 10-22-2012, 02:51 PM   #9
Black94Snake
Scooby Specialist
 
Member#: 274499
Join Date: Feb 2011
Chapter/Region: NESIC
Location: RI
Vehicle:
1994 5.8T Cobra
755rwhp @ 16psi

Default

Don't be stupid friend... Would companies such as Cobb, Perrin, and others put a WBO2 hung in the bellmouth if it was a terrible idea to do so?


Further more, this is copied directly from the AEM instructions.

Quote:
A weld-in M18 X 1.5 boss is supplied for sensor installation. Mount the O2 sensor in the exhaust system at least 18 inches downstream from the exhaust port. If you anticipate high EGT's (over 800C), run a turbocharger, run at high RPM for extended periods of time or plan on running leaded race fuel then you must mount the sensor at least 36 inches or more downstream of the exhaust port
Show me where it says 36" from the turbo.

Reading comprehension owns you.
* Registered users of the site do not see these ads.

Last edited by Black94Snake; 10-22-2012 at 03:08 PM.
Black94Snake is offline   Reply With Quote