View Single Post
Old 03-11-2013, 01:31 AM   #32
Dirtracr95
Scooby Newbie
 
Member#: 346599
Join Date: Feb 2013
Chapter/Region: MWSOC
Location: Des Plaines, IL
Vehicle:
2003 WRX
WRB

Default

Quote:
Originally Posted by Navendra94 View Post
OP, I figured you'd want to give these threads a little read. ( Even though you've probably looked them over before ). They should be able to help you a little bit, if any help is needed ^_^.


http://forums.nasioc.com/forums/show....php?t=1894611

http://forums.nasioc.com/forums/show....php?t=2384760

http://forums.nasioc.com/forums/show....php?t=2044906

http://forums.nasioc.com/forums/show....php?t=2435099
I have read all of those except the 3rd one. I think my first or second post on this forum was in the first link. And the part of that post where I couldnt remember the link to the guy who used s13/14 axles and hubs with his r200 swap is actually the second link.


Here's the Inner cups of my '06 axles sitting next the center diff I welded. Gonna pull the outers off at work since we have a parts washer there.



Need to get the flywheel I picked up cut. Get a stock clutch disk. Clutch slave, Clutch line. I think I am going to split the case on my original trans an just take a look and see if its worth pulling the front diff out of my new trans. If I do that though then I gotta find a different way to plug the axle holes as there wont be the diff for them to clip into.
* Registered users of the site do not see these ads.
Dirtracr95 is offline   Reply With Quote