View Single Post
Old 03-06-2007, 01:24 AM   #17
sponaugle
Scooby Specialist
 
Member#: 4498
Join Date: Feb 2001
Chapter/Region: NWIC
Location: Portland, Oregon
Vehicle:
WRX H6-3.0 Turbo
www.surgelinetuning.com

Default

Quote:
Originally Posted by subie4me View Post
Did supertech change their piston pin clips? Those look like stock ones. I compared, and found the stock around 5 thou smaller diameter wire than supertech. They could jump out, and cause a LOT of damage if not correct.
Those are stock ones. I worked them just a bit to make them push a bit harder. They were very close to the supertec ones, and my first failure was related to the wrist pin coming loose.

Jeff
* Registered users of the site do not see these ads.

Last edited by sponaugle; 09-19-2014 at 12:55 AM.
sponaugle is offline   Reply With Quote