I've got one out in the garage I'm trying to piece together. I'll try and get new pics but I'm lost with all the O-rings. the kit I have is for a 08+.
Here's whats left of my gasket kit, Outfront built the block so they used the rear main and the case half O-rings. I already put on the oil pump crank seal too. Head Gaskets are Cometic but stock ones should be included.
Intake manifold gaskets
Intercooler, Header/ Exhaust, and Oil pump - O-ring looks like 2 o-rings connected within each other (minus oil pump crank seal)
Water pump, Oil pan (rear drain tube o-ring has a channel around it (not sure which side face up), and Misc
Valve seals (Black=Intake, Green=Exhaust), Cam seals, Valve cover gaskets, and crush washers for turbo oil feed and water lines and AVCS Solenoids
Timing covers, 7x o-rings go to rear covers where it bolts to the heads and block, Long rubber seals are for the center cover, and Foam trim sticks to the back of the covers.
Unknowns, Rear main is big and brown and like a cam seal (my last kit had 3x), Oil pump crank seal is smaller than the cam seals and brown (should be the only one that fits in the pump)
Labeled O-rings A-F, if they can be identified I'll update it next to the letters:
A) (2x)
B) (2x)
C)
D)
E)
F) (2x)