View Single Post
Old 06-10-2012, 07:31 AM   #120
Silver_04_WRX_SC
Scooby Specialist
 
Member#: 67198
Join Date: Jul 2004
Chapter/Region: South East
Location: Inman, SC
Vehicle:
2004 WRX Wagon
WRB

Default

Quote:
Originally Posted by juanmedina View Post
Stud remover? To remove the studs from the old turbo and install the in the new turbo?

Just thread one nut backwards and another one the correct way. Tight them against each other and remove the stud by turning the nut threaded backwards. Or buy a new set of studs from Autozone
I tried the two nut method and no luck...the suckers were in there! I ended up going to ACE and they had some new studs. So the car is up and running...very rich at that! So low boost mode it is until I get it tuned.

Quote:
Originally Posted by Noeladams View Post
well crap.... we need to text next time, never been to max speed shop.
Sorry Noel, we were all starving and had no way to let anyone know. I saw a blue WRX drive by with black rims while we were all at Baileys. Was that you?

Here is my cell:
864-804-9379
Jeremy

The food was good, we went downtown...but parking was terrible!
* Registered users of the site do not see these ads.

Last edited by Silver_04_WRX_SC; 06-10-2012 at 07:43 AM.
Silver_04_WRX_SC is offline   Reply With Quote