View Single Post
Old 06-06-2011, 06:07 AM   #3
JarHarms
Scooby Specialist
 
Member#: 138994
Join Date: Jan 2007
Location: apparently I "spread the hate"
Vehicle:
2006 WRX, 6MT, 5x114

Default

I do not have the length specs in hand but both of them are listed in the service manuals. You could also measure the distance from tail shaft to rear diff flange. It would not be much different than measuring to have a jeep drive shaft fabricated. Except that the rear diff does not really articulate.
I would suggest that you switch to the R180 companion flange on your current R160 then fab the drive shaft. This way you are all set for a direct connection come R180 install time.

Quote:
Originally Posted by seanathanq83 View Post
i guess better yet, what is the length of a one piece shaft for both the auto and the sti???? since the oem will be longer because it is two piece
Huh? The distance between the tail shaft and rear diff does not change though.
* Registered users of the site do not see these ads.
JarHarms is offline   Reply With Quote