View Single Post
Old 06-11-2011, 02:07 AM   #16
seanathanq83
Scooby Guru
 
Member#: 173241
Join Date: Feb 2008
Chapter/Region: TXIC
Location: Houston, Tx
Vehicle:
2002 s256 twinscroll
now with one more gear

Default

I am about to get this driveshaft made, and have already ordered the slip yoke so I can see how it fits, I did some more research and found out That the stock slip yoke is .995", the spicer is 1.005" so basically .005" all the way around, does anyone know if this will cause an issue??? Also the only correct flange for the rear pinion flange is for the r180, atleast in slicer brand, I may see if there is another brand that will fit the r160 that way I can just swap flanges when I go to the r180
* Registered users of the site do not see these ads.
seanathanq83 is offline   Reply With Quote