View Single Post
Old 10-30-2012, 09:13 PM   #610
kpluiten
Scooby Guru
 
Member#: 120273
Join Date: Jul 2006
Chapter/Region: SWIC
Location: AZ
Vehicle:
06 WRBWRXWGN
Now with 100% more Spec-C

Default

OK, I think it's time for some updates. Work has been killer and time is tight so I've been doing a lot of this in shorter 1 to 2 hour intervals late at night or in between plans. As a result, my work is scattered and poorly documented.

But everyone likes pictures, right?

I've started reassembling the bay. Slowly. I'm almost done now (minus the motor).

Just getting started:


Unmasking: Paint flakes and dust EVERYWHERE.





Fuse box back in place. All harnesses into and out of the box were stripped and re-wrapped.


I also used this opportunity to remove any extra wires from the harnesses. This included ones for pumps,factory alarm, day time running lights and the like.

The gray plug on the right is for daytime running lights (the module) and the one on the right is for the OEM alarm horn that is normally mounted on the passenger-side strut tower (my can never had one). Both cut.


Wires isolated:




Installing loom to cover the harness:




After that, the entire harness was wrapped with high temperature electrical tape. Heat shielding will be added.

This general process was repeated for all the front clip harnesses.
* Registered users of the site do not see these ads.

Last edited by kpluiten; 10-30-2012 at 09:23 PM.
kpluiten is offline   Reply With Quote