View Single Post
Old 06-30-2003, 02:04 AM   #11
skivvie
Scooby Newbie
 
Member#: 29719
Join Date: Nov 2002
Location: Draper, UT
Vehicle:
'06 WRX Wagon
Silver

Default

9. Alrighty, now you've got the lights out, take them inside.

NOTE: always work on a soft surface like the carpet or towel. I got a few tiny scratches just from putting the lens side down on a piece of cardboard!

Do ONE LIGHT AT A TIME, so when putting one back together you can look at the other as an example.

Now, REMOVE ALL THE LITTLE BLACK PHILLIPS HEAD SCREWS that hold the back of the housing to the front. There are two (2) that are hidden. One under the piece of foam padding as noted in the upper of the photo below (just peel back the foam to get to it) and the other is under the white piece of plastic in the bottom right of the photo below. Just remove the two silver screws holding it down, and the other screw is beneath it.
* Registered users of the site do not see these ads.

Last edited by skivvie; 01-29-2004 at 03:06 PM.
skivvie is offline   Reply With Quote