Thread
:
any diy for tapping the header for egt?
View Single Post
05-10-2010, 03:41 PM
#
6
PERRIN_Jarid
Scooby Newbie
Member#:
214449
Join Date:
Jun 2009
Chapter/Region:
NWIC
Location:
www.perrinperformance.com
Quote:
Originally Posted by
tobylazur
depends on the header. I drilled and tapped my factory header and have had no problems.
Factory exhaust manifold yes? If so there is much more material there to drill thru than an aftermarket stainless header.
*
Registered users
of the site do not see these ads.
PERRIN_Jarid
View Public Profile
Visit PERRIN_Jarid's homepage!
Find More Posts by PERRIN_Jarid