View Single Post
Old 01-21-2006, 03:01 AM   #109
yoojeankim
Scooby Newbie
 
Member#: 69866
Join Date: Sep 2004
Location: Thornton, CO
Vehicle:
2005 WRX STi
CGM

Default

Quote:
Originally Posted by Freon
yoojeankim: have you read this thread? I think it might be a good idea... I posted pretty detailed pictures of my BOV setup which should answer all your questions. TypeC also posted pictures of his BOV setup which also uses the stock piece.

Here's the link again, writeups and pics, etc.:
http://freon.shackspace.com/car/fmic

I'm curious, did anyone else have problems with the MAF housing? My screw holes did not line up. I had to very slightly bore out the two small screw holes in my factory MAF doohickie to make it screw into the included shortram/MAF adapter. Someone in the old thread mentioned this (rather, PMS'd about it), so I'm assuming its just off on all or most of the kits. It is not bad, as there is a washer on the screws and the screws don't create the seal (there is an O-ring on the shaft). But, it is worth mentioning so you don't get too surprised when it doesn't fit perfect out of the box.

yeah i read all pages... trust me

im just trying to make sure before i buy =) KK? cant ppl double check =D
* Registered users of the site do not see these ads.
yoojeankim is offline   Reply With Quote