View Single Post
Old 04-08-2005, 08:29 AM   #2
Targetrex
Scooby Newbie
 
Member#: 71051
Join Date: Sep 2004
Chapter/Region: South East
Vehicle:
2006 WRX STI
World Rally Blue

Default

A few thoughts for you.... You should feel a huge difference at stage 2!?!?

Did it really take 30 minutes for the map to load??? This seems very long, I haven't taken more tha 15 mins. to load a new base map. You also mentioned that you conected the green plugs, did you also connect the white plug that came with your AP. You need both to load a base map. Did you unplug all the connections after you loaded the maps and before you drove it?? The easiest way to check if your right is to connect your AP, start the car and then select check current map on the AP. It should tell you if you running the stage 2 map. Also make sure you loaded the correct base map and not just a real time map. You need to load the stage 2 map as your base. (choose the load a new base map option in the menu) If you plan to only use the stage 2 map then do not load a real time map on top of your base. The base map is what the ECU will run and is the most important step in using the AP. The realtimes are used to swap maps without flashing to the ECU, so if you can't get 93 octane you can load the 91 real time on top of your base map temporarily and then switch back to your base when you get the good stuff (you can switch real times without hooking up any of the plugs once you have loaded your base map).

If all else fails call Cobb
* Registered users of the site do not see these ads.
Targetrex is offline   Reply With Quote