View Single Post
Old 10-27-2012, 07:52 AM   #17
HeroCrank
Scooby Specialist
 
Member#: 301089
Join Date: Nov 2011
Chapter/Region: NESIC
Location: Parts Unknown
Vehicle:
2013 Toyota Tundra
Rock Warrior

Default

Quote:
Originally Posted by sc00ter View Post
Liars! Removing the TMIC took all of 2 minutes. However, re-installing it was a PITA. 20 minutes, two bloody hands, and about 5 "WTF!!" shouts later, I finally got the intercooler aligned perfectly with the turbo/intake manifold.

But it definitely was necessary, getting to that grommet and pulling the vac line through with the TMIC installed would have been a nightmare.

The wiring was pretty easy since I went the route of using "add-a-circuits" to add the wires into the appropriate fuse slots.

After manually calibrating the gauge for my elevation (5200ft) I took a drive to test it and it reads spot on to my Accessport.

Overall I'm very pleased. I can't believe I've gone this long without a dedicated boost gauge.

*Lights up green with the lights on and white with the lights off*
Nice job on the install, getting the Tmic back on sometimes can take a bit, but the more you do it, the easier it becomes. Glad it all worked out
* Registered users of the site do not see these ads.

Last edited by HeroCrank; 10-27-2012 at 08:00 AM.
HeroCrank is offline   Reply With Quote