Hey everyone! I read through all 10 pages of this thread to find the answer to a riddle I am dealing with, but it sounds like no one else has had this problem. If this info is in this thread, I missed it!
I am swapping the 6mt into an 06 wrx. The wire harness on the 6mt has the same connector location as the 5mt. The difference is that the 6mt has 2 round connectors, one black and one white, and the 5mt has one square connector. The vehicle harness calls for one square connector. obviously..
I think the 6mt came out of a 06-07 STI. The whole deal was sold as a "kit", drive axles, rear diff, shifter and everything included. The guy that sold it says that it all came out of another wrx that is going back to the 5mt, so theoretically, it should all work just fine.
I just need help on this little wiring harness issue...