View Single Post
Old 03-07-2006, 09:59 AM   #113
Zumble
Scooby Specialist
 
Member#: 34860
Join Date: Apr 2003
Chapter/Region: Tri-State
Location: NY
Vehicle:
2005 Forester CGM

Default

I just made up a new harness. I found some twisted pair shielded cable at radio shack. I cut the white knock wire out of the stock "harness" and I soldered in on of the wires from the shielded wire. I then used shrink tubing to join the two wires back together at the knocklite end of things. I guess I'll solder a new wire to the shield braid and attach it somewhere to the body ground. I haven't installed the knocklite yet. I only had time to put in the new wire. I still have to figure out which wires to connect for a 05 USDM FXT ECU.

EDIT: I don't think this thread should be in the UTEC section. The knocklite can be used with ANY EM or no EM at all.
* Registered users of the site do not see these ads.

Last edited by Zumble; 03-07-2006 at 10:53 AM.
Zumble is offline   Reply With Quote