View Single Post
Old 03-05-2009, 12:13 PM   #2
Giganticprune
Scooby Specialist
 
Member#: 147662
Join Date: Apr 2007
Chapter/Region: MWSOC
Location: chicago
Vehicle:
2008 STI

Default

ALWAYS sand to bare metal. its not a good ground unless otherwise. make sure its friggin tight too. honestly like 95% of every car audio problem ive dealt with was because of bad grounds.

but on another note, think about it, you hooked up to power antenna wire..most decks will only run that wire hot when youre on the radio, when it needs the antenna. there should be a designated remote wire from that deck. or you can hook up to the red wire from the back of the radio which is a 12v switch.
* Registered users of the site do not see these ads.
Giganticprune is offline   Reply With Quote