View Single Post
Old 11-19-2008, 01:06 PM   #1
Lachute Performance
Former Vendor
Vendor Sales Rating: (8)
 
Member#: 11016
Join Date: Oct 2001
Chapter/Region: E. Canada
Location: Lachute, Quebec - Canada
Default Lachute New Headers + Up pipe

Lachute Performance launches it's new Headers with Up Pipe





Here is a small clip

http://www.youtube.com/watch?v=quif6DqiSJU


Here is the before and after Dynochart on the Lachute GT3076R turbo kit, no tuning whatsoever. Simply do a pull with the stock exhaust manifold and then a second pull with the new kit installed. Same boost, same timing map and so on.





The horsepower are on a chart of 1000hp so each square counts for 40 HP while the torque figures are on a 500ft pounds chart so each square is on 20Ft pounds.

Pretty close to 40 HP gains in the 6000rpm area with about 25ft pounds of torque

Price : 995.00$ USD


A new design for stock location turbo will be released within 2 weeks.

HERE IT IS !

32 HP & 40 Ft pounds of torque on a stock location IHI VF 39 !

Tested on :

STI 2005
Stock exhaust
Stock mapping
Stock air intake

Before / after dyno runs were done within 2 hours !



Impressive gains to say the least !

Warranty : Lifetime warranty against crack and manufacturer defects

Warranty voided when coated or wrapped

Which oil pan is needed : Any USDM 04+ STI and Any JDM V8 and +

No Subframe removal required

No Plastic undertray removal required

__________________
Julien Pilon
Lachute Performance
* Registered users of the site do not see these ads.

Last edited by Lachute Performance; 02-19-2009 at 10:58 AM. Reason: Update
Lachute Performance is offline