Quote:
Originally Posted by TypeC
I had my machine shop measure and hone my cylinders to fit 99.5mm pistons with .0026" PW clearance. The factory service limit is .002, so assuming the sleeves are straigh (Taper, round, etc) the normal bore should fit. But then again, this was on a 5K mile block.
But yeah, if they are custom pistons, you'll be SOL if they don't fit (no exchanging).
|
yeah, 5k and 58k are a bit different.
If you were able to achieve those tolerances on each piston that's awesome. Was your block an all A or all B block? all my blocks except one have been ABAB blocks. Did they do it by a data sheet or did they actually measure each piston?