View Single Post
Old 04-28-2010, 07:23 PM   #58
the_virus
Scooby Newbie
 
Member#: 104153
Join Date: Jan 2006
Chapter/Region: SWIC
Location: AZ
Vehicle:
2011 ForesterXT
Black

Default

bringing this back from the dead.

I just had a new 2.0 put in and put around 3k miles on it and BAM!!!. CEL comes on and I get this code.

I replaced the CPS and cleared the code and it ran worse than it did before, barly even started. So I put the old one back in and it was gone. I drove around for a few miles with the old one and without getting on the gas and it was fine. Once I hit over 3500rpm on WOT, CEL flips back on.

I have no clue what is going on. Someone on here mentioned using a small washer as a shim for the sensor but there was never one on there.

Please HELP!!
* Registered users of the site do not see these ads.
the_virus is offline   Reply With Quote